Equipment needed:

The machine in mode 3

A kettle

1 or 2 sheets of paper towel

WD40 type product

Procedure:
1st step:

Fill the airbrush vial with boiling water to the last line

Recap the vial

2nd step:

From the 8th stroke to the 4th stroke without stopping

Take a sheet of paper towel and the airbrush

Exhale in mode 3 on the paper towel by pulling it all the way back

Step 3:

From the 4th stroke to the last without stopping

When you are halfway through the vial, you plug the airbrush tip against the paper towel for 2 seconds (this will make bubbles in the vial, which is quite normal)

Immediately afterwards you expel as in step two for 1 second

Step 4:

When the vial is empty, unscrew it, and apply WD40 in the hole of the gun

Unscrew the black part at the back

Unscrew the triangular screw

Move the rod back and forth to diffuse the WD40

Put the parts back on

Once finished, you can resume your sessions by putting product back into the vial.
Visit our Sun Cosmetics YouTube channel to see the process in video format.
It is important to do the cleaning every week (even if you have not used it) to avoid damaging the machine.

You have a clog in the front of your airbrush. You should therefore refer to the cleaning steps mentioned in the question “How do I maintain and clean my device?” or on our YouTube channel Sun Cosmetics France.

In case of unresolved problems, please contact us by email at contact@sun-cosmetics.fr or by phone at +33 9 54 55 71 11.

Unscrew the hose (from the gun) behind your machine and see if the machine starts up. If this is not the case, your machine must have a defect, please contact us by e-mail at contact@sun-cosmetics.fr or by telephone on +33 9 54 55 71 11.

The appliance has a 2-year parts and labor warranty. You can also take out an additional extended warranty (including parts and labor) for a period of 3 years.